Important
To replace the fuser assembly correctly, be aware of the three alignment points: There
are two alignment points in the front and one in the back of the assembly. Proper
alignment ensures proper performance.
1. Place the Fuser Belt Module Handles on each side of the belt and reinsert the required
Fuser Belt Module into the Fuser Assembly.
2. Using the handles, position the Belt Module into the Fuser Assembly using the three
alignment points. The Belt Module can be moved front to back and side to side to
achieve the proper placement.
Make sure the fuser is seated correctly and completely or the Fuser Top Cover will
not close and machine damage may result.
3. To validate the Belt Module is installed properly, gently close the Fuser Top Cover. If
it closes completely, the module is installed correctly. If it does not close, try to reinstall
the Fuser Belt Module again. Leave the Top Cover open.
4. Replace the wire bundle into the harness clip. Reconnect the three white connectors
at the front of the Fuser by pushing into place.
Xerox
®
Versant
®
3100 Press6-36
User Guide
Maintenance
To Next Page
Loading...
