Circuit Breaker Switch
The Circuit Breaker Switch located at the rear of the press. Initially check to make sure
this switch is set to On when the press is shipped.
Main Power Switch
The Main Power Switch located inside the Center Front Door.
Note
Switching off the Main Power also shuts off the Main Power Status LED.
Tip
Before switching off the press, ensure that it is not in Power Saver Mode.
This switch is used mainly by the Xerox Service Representative when servicing the press.
In rare troubleshooting situations, you may be directed to power off the press with this
switch.
Power On / Off Button
The Power On / Off Button is located on the right side of the Control Panel. Use this
button to power ON or OFF the press.
2-9Xerox
®
Versant
®
3100 Press
User Guide
Getting Started