Xerox Versant 3100 Press User Manual

Performance Specifications
DescriptionFeature
The press warmup times vary depending on the current state / mode
of the press. Warmup times are listed as follows:
Press Warmup Time
• From a cold start (either power on or power saver mode), less than
5 minutes
• From Sleep Mode / Power Saver, less than 5 minutes
• From Standby Mode, less than 1 minute
• When switching print modes (such as from black only to full color),
approximately 2 minutes
This is the minimum time from when the press receives a job from
the print server to the time when the trail edge of the first print passes
through the press exit sensor.
Time of First Print Out of
Press
• From a cold start (power on or power saver), the system takes less
than 5 minutes to start printing
• From standby mode, the system usually takes less than 1 minute
to the start printing
Environmental Specifications
The press enters the Power Saver mode after fifteen minutes of inactivity. The factory
default time of fifteen minutes can be changed when logged on as the administrator.
For more information, refer to the System Administration Guide.
The temperature and relative humidity of the room where the press is located must be
within the minimum and maximum allowable temperature and relative humidity limits
for the press system to operate correctly.
PressOperating Environment
50° to 90° F (10° to 32° C)Required Temperature Range
15% to 85% Relative Humidity (RH)Required Relative Humidity
Max of 8,200 ft. (2,500 meters)Altitude(above sea level)
Sound Pressure Levels
• Running: 65 dBA (decibels (Acoustics))
• Standby: 40.8 dBA
Xerox
®
Versant
®
3100 Press8-2
User Guide
Specifications

Xerox Versant 3100 Press Specifications

General

Brand	Xerox
Model	Versant 3100 Press
Category	Printer
Language	English