Xerox Versant 3100 Press User Manual

Power On / Off the Press
1. To switch on the press, check that the Main Power switch behind the Center Front
Door is On.
2. Press the Power On / Off button on top of the press to the ON position.
The Ready Indicator light displays green.
A screen message advises of a short wait while the fuser warms up and the press runs
a system check. You can set features for a job during this time and the printing process
will start automatically when the press is ready.
3. To switch off, press the Power On / Off button to the Off position.
Note
Allow the press to remain off for a minimum of 10 seconds before switching on the
power again.
Power Saver Mode
The Power Saver feature allows the press to enter a reduced power consumption mode
when all print jobs have completed and there are no jobs currently processing. There
are two power saving modes: Low Power and Sleep.
• Low Power: After remaining inactive for a preset time period, the press enters the
Low Power mode.
• Sleep: After entering Low Power mode and remaining inactive for another preset
time period, the press enters the Sleep mode.
By default, the press automatically enters the Low Power mode after 1 minute of
inactivity. After 1 minute of inactivity, the press then enters Sleep mode. These time
intervals for both modes can be changed by the system administrator.
Refer to the following example:
• Low Power Mode is set to 1 minute.
• Sleep Mode is set to 10 minutes.
• Sleep Mode activates after 10 minutes of total inactivity and not 10 minutes after
the Low Power Mode begins.
Xerox
®
Versant
®
3100 Press2-10
User Guide
Getting Started

Xerox Versant 3100 Press Specifications

General

Brand	Xerox
Model	Versant 3100 Press
Category	Printer
Language	English