Xerox Versant 3100 Press - Stock Library Manager Default Settings

Problem
Trail Edge Deletions
Suggested Solutions
Change the Transfer Output Adjustment for Trail Edge setting.
• This feature is used to adjust the voltage ratio on the Secondary Bias Transfer Roll (BTR),
where the image is transferred from the belt to the paper.
• This feature can be found in Stock Library Manager > Stock Properties > Advanced Setup >
Transfer Output Adjustment for Trail Edge.
• Decrease the Transfer Output Adjustment for Trail Edge in increments of 5 to 10%. After
every increment adjustment run test prints and evaluate the output to determine if addi-
tional adjustment is necessary.
Stock Library Manager Default Settings
The information provides the default values, ranges, and recommended incremental
adjustments for the various Stock Library Manager features, options, and settings.
Alignment Profile
Recommended
Incremental Ad-
justment
Available RangeAdjustment Step
Increments
Default ValueOption / Setting
Registration
Determined by
test print output
-2.0 to 2.0 mm0.10.0
Side 1, Side
Determined by
test print output
-2.0 to 2.0 mm0.10.0Side 1, Lead
Determined by
test print output
-2.0 to 2.0 mm0.10.0Side 2, Side
Determined by
test print output
-2.0 to 2.0 mm0.10.0Side 2, Lead
Perpendicularity
Determined by
test print output
-1.0 to 1.0 mm0.10.0Side 1
Determined by
test print output
-1.0 to 1.0 mm0.10.0Side 2
Skew
Xerox
®
Versant
®
3100 Press7-22
User Guide
Troubleshooting