Suggested Solutions
- Z-Fold Half-Sheet (available with the optional C/Z Folder)
Create a new or use an existing Fold Adjustment Profile. The following is a summary of the
steps required for creating a new or using an existing procedure.
Note
This option is accessed from Stock Library Manager > Profiles > Fold Adjustment Profile.
1. From the Stock Library Manager main window, select Profiles.
2. Select the Fold Adjustment tab.
3. Select either the New or Edit button.
If you are editing an existing fold adjustment, select the desired profile from the list and
then select the Edit button.
4. Type in a new name, or if desired, edit the existing name.
5. To complete the procedure, refer to Stock Library Manager > Help, the Fold Adjustment
Procedures section. Select the desired fold adjustment procedure and complete the pro-
cedure for creating a new or editing an existing Fold Adjustment Profile.
Problem
Smear 208 mm from the Lead Edge
Suggested Solutions
1. Confirm the media being used is compatible with the press, is within supported specifica-
tions, and in good condition.
2. Change the Adjustment of Paper Speed at Transfer setting.
• Use this feature to adjust the paper speed in the transfer unit.
• The option can be found in Stock Library Manager > Stock Properties > Advanced
Setup > Adjustment of Paper Speed at Transfer.
• Based on the output, decrease Adjustment of Paper Speed at Transfer in increments
of 0.05%. After every increment adjustment run test prints and evaluate the output to
determine if additional adjustment is necessary.
• Transfer defects may occur when paper speed is too fast or too slow.
3. Change the Fuser Speed Adjustment setting.
• This feature can be used to correct the issue of a smear at 208 mm from the Lead Edge
(LE). Increase the fuser speed to correct the issue.
• This feature also impacts print quality.
- Increasing fuser speed extends the image. If fuser speed is set too high it may
cause paper jams.
- Decreasing fuser speed shrinks the image.
• The option can be found in Stock Library Manager > Stock Properties > Advanced
Setup > Fuser Speed Adjustment.
• Increase fuser speed in increments of 0.5%. After every increment adjustment run test
prints and evaluate the output to determine if additional adjustment is necessary.
7-21Xerox
®
Versant
®
3100 Press
User Guide
Troubleshooting
To Next Page
Loading...
