Xerox Versant 3100 Press - Page 138

Suggested Solutions
1. Switch On the Pre Gate Roll Adjustment.
Important
This option must be On to allow for the custom setting of the Aligner Roll Pressure option.
• Access the option from Stock Library Manager > Stock Properties > Advanced Stock
Setup > Pre Gate Roll Adjustment.
• Select On under the Pre Gate Roll Adjustment from the drop-down menu.
2. Adjust the Aligner Roll Pressure.
• Access the feature from Stock Library Manager > Stock Properties > Advanced Stock
Setup > Aligner Roll Pressure.
• Based on the output, increase or decrease the Aligner Roll Pressure in increments of
five or ten.
• After each incremental adjustment, run test prints and evaluate the output prints to
determine if additional adjustments are required.
Problem
Fold Adjustment
Suggested Solutions
Tip
The Fold Adjustment Profile is available only when the system configuration includes one of
the following:
• Production Ready (PR) Booklet Maker Finisher (for Bi-Fold / Single-Fold), or
• Optional C/Z Folder with one of the following optional finishers:
- PR Finisher, or
- PR Booklet Maker Finisher, or
- PR Finisher Plus
For detailed information about these finishing devices, refer to the Optional Devices Guide for
Xerox
®
Versant
®
3100 Press.
Create and/or use an existing Fold Adjustment Profile.
Note
Before creating a new or using an existing profile or performing any alignment adjustments,
read / review the entire Fold Adjustment Profile section in the Stock Library Manager Help.
Refer to the Stock Library Manager > Help > Fold Adjustment Profile,
• Depending on your system configuration, the following fold adjustments are available:
- Bi-Fold Single Sheet (available only with the PR Booklet Maker Finisher)
- Bi-Fold Multiple Sheets (available only with the PR Booklet Maker Finisher)
- Bi-Fold Multiple Sheets Stapled (available only with the PR Booklet Maker Finisher)
- C-Fold (available with the optional C/Z Folder)
- Z-Fold (available with the optional C/Z Folder)
Xerox
®
Versant
®
3100 Press7-20
User Guide
Troubleshooting