Suggested Solutions
• If the fuser temperature is too high when printing on lightweight paper, it may cause
blocking, media damage, or paper jams at the peeling unit in the fusing module.
• If the fuser temperature is too low, it may cause poor fusing on higher-density image
areas and toner may peel off the printed output.
• This feature is accessed from Stock Library Manager > Stock Properties > Advanced
Stock Setup > Fuser Temperature Adjustment.
• Based on the printed output, increase or decrease the Fuser Temperature Adjustment
in increments of 1° or 2°.
• After each incremental adjustment, run test prints and evaluate the output to determine
if additional adjustments are required.
2. If feeding paper from trays 6-9 and if the paper is damp, confirm that the Enable Tray
Heater feature is Enabled (checked).
Note
Enable Tray Heater is available only for trays 6-9.
• Use this feature to Enable (checked) or Disable (unchecked) the tray heater.
• The tray heater warms the air that is blown into the tray by Tray Air Assist and helps
prevent paper jams and multifeeds by loosening contact between sheets.
• The tray heater may partially dry paper and affect print quality. If print quality is affected
by dry paper, disable the tray heater.
Note
Disabling the tray heater may result in an increase of multifeeds.
• This feature is accessed from Stock Library Manager > Stock Properties > Advanced
Stock Setup > Enable Tray Heater.
• To Enable (check) the box for Enable Tray Heater.
Problem
Edge Damage
Suggested Solutions
Change the Aligner Roll Pressure setting.
Tip
Changing the default setting of 0 (zero) is a temporary solution because environmental condi-
tions vary from day to day. Upon completion of the print job, the recommendation is to return
the option to its default setting.
• Use this feature to adjust the aligner roll pressure.
• Some types of coated paper slip and skew, thereby misregistering the image on the output
prints. In this case, you may need to increase the Aligner Roll Pressure to apply more force
to hold down the paper to compensate for the slippage and skewing.
• Some lightweight papers may have too much roll pressure applied to them, causing edge
damage to the output prints. In this case, you may need to decrease the roll pressure to
apply less force to hold down the paper.
To change the Aligner Roll Pressure setting, perform the following:
7-19Xerox
®
Versant
®
3100 Press
User Guide
Troubleshooting
To Next Page
Loading...
