Cleaning the Raster Output Scanner (ROS) Window Areas
Unfused dry ink / toner collects on the four color raster output scanner (ROS) window
areas located just above the drum cartridge drawer inside the press. Contaminated ROS
windows can cause a white streak defect on your printed output.
If you notice white or light streaks on prints, to resolve this issue, clean the ROS windows
with the following procedure.
Important
Use only the cleaning wand and cloth pad provided when performing this procedure.
Do not use any other cleaning device, liquid solutions, or cloths.
1. Open the left and center front doors of the press.
2. Locate and remove the cleaning wand tool stored on the inside panel of the left front
door.
3. Make sure the pad at the tip of the wand is clean.
Several pads are provided with the cleaning wand when the press is installed.
Note
Replace the pad when it becomes a dark color. Always use a clean pad in order to
ensure optimum image quality on the printed output.
To acquire additional pads, contact your Xerox Service Representative.
4. Clean one of the ROS windows:
Xerox
®
Versant
®
3100 Press6-4
User Guide
Maintenance
To Next Page
Loading...
