Xerox Versant 3100 Press User Manual

Note
The dry ink / toner material inside the new cartridge is compact. Loosen and
redistribute the dry ink / toner material before placing into the dry ink / toner slot.
a) With one hand on either side of the cartridge, vigorously shake and rotate the
new cartridge up and down and then left and right for 30 seconds.
b) Test whether the dry ink / toner material is distributed sufficiently by turning the
auger on the end of the cartridge.
c) If the auger does not turn easily, continue to shake the cartridge and loosen the
dry ink / toner material. When the auger turns without resistance, the dry ink /
toner cartridge is ready for installation.
7. Install the dry ink /toner cartridge by aligning it straight out from the press and gently
sliding in until it stops.
8. Close the dry ink / toner cover.
If the cover does not close completely, make sure the cartridge is in the lock position
and is installed into the appropriate dry ink / toner location.
Note
After you replace a dry ink / toner cartridge, the system automatically resets the High
Frequency Service Item (HFSI) usage counter for this CRU to zero (0). Check the
consumables Supplies screen to verify the reset and new status.
6-21Xerox
®
Versant
®
3100 Press
User Guide
Maintenance

Xerox Versant 3100 Press Specifications

General

Brand	Xerox
Model	Versant 3100 Press
Category	Printer
Language	English