Xilinx MicroBlaze - Page 280

MicroBlaze Processor Reference Guide 281
UG984 (v2018.2) June 21, 2018 www.xilinx.com
Chapter 5: MicroBlaze Instruction Set Architecture
Latency
• 1 cycle with C_AREA_OPTIMIZED=0 or 2
• 2 cycles with
C_AREA_OPTIMIZED=1
Notes
The byte reversed instruction is only valid if MicroBlaze is configured to use reorder instructions
(C_USE_REORDER_INSTR = 1).
The extended address instruction is only valid if MicroBlaze is configured to use extended address
(C_ADDR_SIZE > 32).
Send Feedback