Yamaha Scorpio - Page 173

6 - 15
CHAS
FRONT BRAKE
5.Install:
●
Brake pads
●
Brake pads springs
***********************************************
Installation steps:
●
Connect a suitable hose
1
tightly to the
brake caliper bleed screw
2
. Put the other
end of this hose into an open container.
●
Loosen the brake caliper bleed screw and
using a finger push the caliper pistons into
the brake caliper.
●
Tighten the brake caliper bleed screw.
●
Install new brake pad springs and a new
brake pads.
●
Install the brake caliper
3
and retaining bolts
4
/brake caliper bolts
5
.
***********************************************
T
R
.
.
Brake caliper bleed screw:
6 Nm (0.6 m • kg)
T
R
.
.
Retaining bolt:
27 Nm (2.7m • kg)
Brake caliper bolt:
30 Nm (3.0 m • kg)
6.Inspect:
●
Brake fluid level
Refer to the “BRAKE FLUID LEVEL
INSPECTION” section in CHAPTER 3.
a
“LOWER” level line
7.Check:
●
Brake lever operation
Soft or spongy feeling
→
Bleed the brake
system.
Refer to the “AIR BLEEDING (HYDRAULIC
BRAKE SYSTEM)” section in CHAPTER 3.