Yamaha Scorpio - Brake Pad Replacement

6 - 14
CHAS
FRONT BRAKE
CAUTION:
Disc brake components rarely require dis-
assembly. DO NOT:
●
Disassemble components unless abso-
lutely necessary;
●
Use solvents on internal brake compo-
nents;
●
Use spent brake fluid for cleaning; (use
only clean brake fluid)
●
Allow brake fluid to come in contact with
the eyes, as this may cause eye injury;
●
Splash brake fluid onto painted surfaces
or plastic parts, as this may cause dam-
age;
●
Disconnect any hydraulic connection, as
this would require the entire brake sys-
tem to be disassembled, drained,
cleaned, properly filled and bled after
reassembly.
BRAKE PAD REPLACEMENT
NOTE:
It is not necessary to disassemble the brake
caliper and brake hose to replace the brake
pads.
1.Loosen:
●
Retaining bolts
2.Remove:
●
Brake caliper bolts
●
Brake caliper
3.Remove:
●
Retaining bolts
1
●
Brake pads
2
NOTE:
●
Install new brake pad springs when the
brake pads have to be replaced.
●
Replace the brake pads as a set if either is
found to be worn to the wear limit.
4.Measure:
●
Brake pad wear limit
a
Out of specification
→
Replace the brake
pads as a set.
Brake pad wear limit:
0.8 mm