6 - 18
CHAS
FRONT BRAKE
1.Install:
●
Brake caliper
1
(temporarily)
●
Copper washers
2
●
Brake hose
3
●
Union bolt
4
WARNING
Proper brake hose routing is essential to
insure safe motorcycle operation. Refer to
the “CABLE ROUTING” section.
CAUTION:
When installing the brake hose onto the
brake caliper
1
, make sure that the brake
pipe
a
touches the projection
b
on the
brake caliper.
New
T
R
.
.
26 Nm (2.6 m • kg)
2.Install:
●
Brake pad springs
●
Brake pads
●
Brake caliper
●
Brake caliper retaining bolt
T
R
.
.
27 Nm (2.7 m • kg)
3.Fill:
●
Brake master cylinder reservoir
(with the specified amount of the recom-
mended brake fluid)
WARNING
●
Use only the designated brake fluid.
Other brake fluids may cause the rubber
seals to deteriorate, causing leakage and
poor brake performance.
●
Refill with the same type of brake fluid
that is already in the system. Mixing
brake fluids may result in a harmful
chemical reaction, leading to poor brake
performance.
Recommended brake fluid:
DOT 3 or 4
To Next Page
