6 - 28
CHAS
FRONT FORK
NOTE:
●
When assembling the front fork leg, be sure
to replace the following parts:
-oil seal
-dust seal
●
Before assembling the front fork leg, make
sure that all of the components are clean.
1.Install:
●
Damper rod
1
●
Oil lock piece
2
CAUTION:
Allow the damper rod to slide slowly down
the inner tube until it protrudes from the
bottom of the inner tube. Be careful not to
damage the inner tube.
2.Lubricate:
●
Inner tube’s outer surface
3.Tighten:
●
Damper rod bolt
1
NOTE:
While holding the damper rod with the damper
rod holder
2
and T-handle
3
, tighten the
damper rod bolt
1
.
Recommended lubricant:
Fork oil 10 W or equivalent
Damper rod holder (19 mm):
90890-04084
T-handle:
90890-01326
T
R
.
.
30 Nm (3.0 m • kg)
4.Install:
●
Oil seal
1
(with the fork seal driver weight and adapter)
Fork seal driver weight
2
:
90890-01367
Fork seal driver attachment (ø33)
3
:
90890-01368
To Next Page
