7 - 10
– +
ELEC
IGNITION SYSTEM
C0NTINUITY
OUT OF
SPECIFICATION
2.Ignition spark gap
●
Disconnect the spark plug cap from the
spark plug.
●
Connect the ignition checker
1
between
cylinder head and spark plug cap
2
, and
set the specified spark gap
3
.
●
Turn the main switch to “ON”, then apply
clutch lever or shift the transmission into
neutral.
●
Push the start switch or kick the kick crank.
●
Check the ignition spark condition.
Minimum spark gap:
6 mm
*
SPARK
Ignition circuit is good.
3.Spark plug cap resistance
●
Remove the spark plug cap.
●
Connect the pocket tester (
Ω
×
1k) to the
spark plug cap.
MEETS
SPECIFICATION
●
Checking the spark plug cap for the speci-
fied resistance.
Spark plug cap resistance:
10 k
Ω
at 20°C
*
OUT OF SPECIFICATION
Replace spark plug cap.
To Next Page
