4 - 11
ENG
NOTE:
TDC on compression stroke check:
●
Both rocker arms must have a valve clearance
when the “l” mark
a
on the flywheel is aligned
with the slit
b
on the crankcase cover.
●
If not, give the crankshaft one counter clock-
wise turn to meet above condition.
***********************************************
7.Loosen:
●
Bolt (camshaft sprocket)
1
NOTE:
Hold the crankshaft end with a wrench
2
.
8.Remove:
●
Cam chain tensioner
1
9.Remove:
●
Camshaft sprocket
NOTE:
Fasten a safety wire to the cam chain.
10.Remove:
●
Engine mounting bracket
Refer to the “ENGINE REMOVAL” section.
11.Remove:
●
Cylinder head
1
NOTE:
Loosen the bolts in this stage, using a criss-
cross pattern.
CYLINDER HEAD
To Next Page
