YASKAWA GA800

Keypad Use and Test Run
3
3.4 Keypad Operation
YASKAWA TOEPYAIGA8002B GA800 Drive Programming 553
5. Push or to select the monitor group, then push .
6. Push or to change the monitor number to show the monitor item.
Note:
Push to return to the previous page.
◆ Set Custom Monitors
You can select and register a maximum of 12 monitoring items to regularly show on the keypad.
This procedure shows how to set the motor speed to [Custom Monitor 1].
1. Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If the keypad does not show [Home] on , push (Back) to show [Home] on .
2. Push (Menu).
3. Push or to select [Monitors], then push .
4. Push or to select [Custom Monitor], then push (Setup).