1.13 o: Keypad-Related Settings
100 YASKAWA TOEPYAIGA8002B GA800 Drive Programming
1.13 o: Keypad-Related Settings
◆ o1: Keypad Display
No.
(Hex.)
Name Description
Default
(Range)
Ref.
o1-01
(0500)
RUN
User Monitor Selection
Sets the U monitor for the Drive Mode. This parameter is only available when you use an
LED keypad.
106
(104 - 855)
511
o1-02
(0501)
RUN
Monitor Selection at
Power-up
Sets the monitor item that the keypad screen shows after energizing the drive. Refer to “U:
Monitors” for information about the monitor items that the keypad screen can show. This
parameter is only available when you use an LED keypad.
1 : Frequency Reference (U1-01)
2 : Direction
3 : Output Frequency (U1-02)
4 : Output Current (U1-03)
5 : User Monitor (o1-01)
1
(1 - 5)
511
o1-03
(0502)
Frequency Display Unit
Selection
Sets the display units for the frequency reference and output frequency.
0 : 0.01Hz units
1 : 0.01% units
2 : min
-1
(r/min) unit
3 : User Units
Determined by A1-02
(0 - 3)
511
o1-04
(0503)
V/f Pattern Display Unit
Sets the setting unit for parameters that set the V/f pattern frequency.
0 : Hz
1 : min
-1
(r/min) unit
Determined by A1-02
(0, 1)
512
o1-05
(0504)
RUN
LCD Contrast
Adjustment
Sets the contrast of the LCD display on the keypad.
5
(0 - 10)
513
o1-10
(0520)
User Units Maximum
Value
Sets the value that the drive shows as the maximum output frequency.
Determined by o1-03
(1 - 60000)
513
o1-11
(0521)
User Units Decimal
Position
Sets the number of decimal places for frequency reference and monitor values.
0 : No Decimal Places (XXXXX)
1 : One Decimal Places (XXXX.X)
2 : Two Decimal Places (XXX.XX)
3 : Three Decimal Places (XX.XXX)
Determined by o1-03
(0 - 3)
513
o1-24 to o1-35:
(11AD - 11B8)
RUN
Custom Monitor 1 to 12
Sets a maximum of 12 monitors as user monitors. This parameter is only available when
using an LCD keypad.
o1-24: 101
o1-25: 102
o1-26: 103
o1-27 to o1-35: 0
(0, 101 - 999)
513
o1-36
(11B9)
RUN
LCD Backlight
Brightness
Sets the intensity of the LCD keypad backlight.
5
(1 - 5)
514
o1-37
(11BA)
RUN
LCD Backlight ON/OFF
Selection
Sets the automatic shut off function for the LCD backlight.
0 : OFF
1 : ON
1
(0, 1)
514
o1-38
(11BB)
RUN
LCD Backlight Off-Delay
Sets the time until the LCD backlight automatically turns off.
60 s
(10 - 300 s)
514
o1-39
(11BC)
RUN
Show Initial Setup Screen
Sets the function to show the LCD keypad initial setup screen each time the drive is
energized. This parameter is only available when using an LCD keypad.
0 : No
1 : Yes
1
(0, 1)
514
To Next Page
Loading...
