3.4 Keypad Operation
556 YASKAWA TOEPYAIGA8002B GA800 Drive Programming
6. Push .
7. Push or to select the monitor number to register, then push .
Enter the three digits in “x-xx” part of monitor Ux-xx to identify which monitor to output. For example, to show
monitor U1-01 [Frequency Reference], set it to "101" as shown in this figure.
The configuration procedure is complete.
◆ Show Monitors as Bar Graphs
The procedure in this section shows how to show a specific monitor as a bar graph. You can show a maximum of
three.
1. Push (Home) to display the HOME screen.
Note:
• [Home] appears in the upper right hand corner of the screen when in HOME mode.
• If [Home] is not shown on , push (Back) to show [Home] on .
2. Push (Menu).
3. Push or to select [Display Monitor], then push .
4. Push or to select [Display Bar Graph], and push .
To Next Page
Loading...
