YASKAWA GA800

Keypad Use and Test Run
3
3.4 Keypad Operation
YASKAWA TOEPYAIGA8002B GA800 Drive Programming 579
9. Push or to select the hour or minute, then push or to change the value.
10. When you are done setting the time, push .
The procedure for setting the date and time is complete.
◆ Set Parameters Using the Setup Wizard
The Setup Wizard lets users follow simple messages on the keypad to set these basic parameters:
• Frequency reference source
• Input signal level
• Run command source
• Duty Rating
• Motor type
• Control method
• Maximum frequency
• Input/output settings
Note:
The Setup Wizard function will initialize all parameters before it sets the basic parameters.
1. Push (Home) to show the HOME screen.
Note:
• The keypad will show [Home] in the top right corner when the HOME screen is active.
• If [Home] is not shown on , push (Back) to show [Home] on .
2. Push (Menu).
3. Push or to select [Initial Setup], then push .