YASKAWA GA800

3.4 Keypad Operation
566 YASKAWA TOEPYAIGA8002B GA800 Drive Programming
◆ Save a Backup of Parameters
You can save a backup of the drive parameters to the keypad. The keypad can store parameter setting values for a
maximum of four drives in different storage areas. Making backups of the parameter settings can save time when
setting parameters after replacing a drive. If you set up more than one drive, you can copy the parameter settings from
a drive that completed a test run to the other drives.
Note:
• Be sure to stop the monitor before backing up parameters.
• While making a backup, the drive will not accept Run commands.
• The DriveWorksEZ PC software password is required to back up qx-xx [DriveWorksEZ Parameter] and rx-xx [DWEZ Connection
Parameter]. If an incorrect password is entered, the drive detects PWEr [DWEZ Password Missmatch].
1. Push (Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If the screen does not show [Home] for , push (Back), and then push to show [Home].
2. Push (Menu).
3. Push or to select [Parameter Backup/Restore], then push .
4. Push or to select the items to back up, then push .
5. Push or to select [Backup (drive → keypad)], then push .