3.4 Keypad Operation
568 YASKAWA TOEPYAIGA8002B GA800 Drive Programming
6. Push or to select the backed-up parameter data, then push .
The keypad will show the “End” message when the write process is complete.
Note:
Different settings and conditions will change the keypad display.
A - A1-02 [Control Method Selection]
settings
B - o2-04 [Drive Model (KVA) Selection]
settings (2 or 3 digits)
C - Presence of DriveWorksEZ
parameter backup
D - Parameter backup data is not
registered
E - Backup data does not contain the
date Information
F - Backup date
◆ Verify Keypad Parameters and Drive Parameters
This procedure verifies that the parameter setting values that were backed up in the keypad agree with the parameter
setting values in the drive.
Note:
• Always stop the drive before you start to verify the parameters.
• The drive does not accept Run commands while restoring parameters.
1. Push (Home) to show the HOME screen.
Note:
• When the drive is in HOME Mode, the screen shows [Home] in the upper right-hand corner of the screen.
• If the screen does not show [Home] for , push (Back), and then push to show [Home].
2. Push (Menu).
3. Push or to select [Parameter Backup/Restore], then push .
To Next Page
Loading...
