3.4 Keypad Operation
560 YASKAWA TOEPYAIGA8002B GA800 Drive Programming
6. Push .
7. Push or to select the monitor number to register, then push .
When the U parameters are on the display as "Ux-xx", the three digits in "x-xx" identify which monitor to
output. For example, to show monitor U1-01 [Frequency Reference], set it to "101" as shown in this figure.
8. Push or to select [Trend Plot 1 Scale Minimum Value], then push .
9. Push or to select the specified digit, then push or to select the correct number.
• Push (Default) to set the parameters to the factory default.
• Push (Min/Max) to move between the minimum value and maximum value.
10. Push to keep the changes.
11. Push or to select [Trend Plot 1 Scale Maximum Value], then push .
To Next Page
Loading...
