YASKAWA GA800

Mechanical & Electrical Installation
4
4.5 Control Circuit Wiring
YASKAWA TOEPYAIGA8002B GA800 Drive Programming 629
Note:
You can temporarily store the LED status ring board with the temporary placement holes on the drive. The location of the
temporary placement holes is different on different drive models.
A - Drive front
B - LED status ring board
C - Temporary placement holes
Figure 4.21 Remove the LED Status Ring Board
A - Drive front
B - LED status ring board
C - Temporary placement holes
Figure 4.22 Remove the LED Status Ring Board
A - Drive front
B - LED status ring board
C - Temporary placement holes
Figure 4.23 Remove the LED Status Ring Board
2. Refer to the following figure and wire the control circuit.
WARNING! Fire Hazard. Tighten all terminal screws to the correct tightening torque. Connections that are too loose or too
tight can cause incorrect operation and damage to the drive. Incorrect connections can also cause death or serious injury
from fire.