EasyManua.ls Logo

YASKAWA JUSP-MD D01A Series - Page 347

YASKAWA JUSP-MD D01A Series
363 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
10 Appendix
10.2.2 Parameters
10-28
Pn50D
2 Input Signal Selection 4 0000 to FFFF
8888 After restart Setup
Pn50E
2 Output Signal Selection 1 0000 to 3333
3211 After restart Setup
(cont’d)
Parameter
No.
Size
Name
Setting
Range
Units
Factory
Setting
When Enabled
Classifi-
cation
Reference
Section
/ZCLAMP Signal Mapping (Zero clamp when ON (closed))
Reference
Section
0 Active when CN1-40 input signal is ON (closed).
5.3.5
1 Active when CN1-41 input signal is ON (closed).
2 Active when CN1-42 input signal is ON (closed).
3 Active when CN1-43 input signal is ON (closed).
4 Active when CN1-44 input signal is ON (closed).
5 Active when CN1-45 input signal is ON (closed).
6 Active when CN1-46 input signal is ON (closed).
7 Always active (fixed).
8 Not active (fixed).
9 Active when CN1-40 input signal is OFF (open).
A Active when CN1-41 input signal is OFF (open).
B Active when CN1-42 input signal is OFF (open).
C Active when CN1-43 input signal is OFF (open).
D Active when CN1-44 input signal is OFF (open).
E Active when CN1-45 input signal is OFF (open).
F Active when CN1-46 input signal is OFF (open).
/INHIBIT Signal Mapping (Reference pulse inhibit when ON (closed))
Reference
Section
0 to F
Same as /ZCLAMP Signal Mapping.
5.4.8
/G-SEL Signal Mapping (Gain change when ON (closed))
Reference
Section
0 to F
Same as /ZCLAMP Signal Mapping.
6.7.6
Reserved (Do not change.)
4th 3rd 2nd 1st
digit digit digit digit
n.

Positioning Completion Signal Mapping (/COIN)
Reference
Section
0 Disabled (the above signal is not used.)
5.4.6
1 Outputs the signal from CN1-25, -26 output terminal.
2 Outputs the signal from CN1-27, -28 output terminal.
3 Outputs the signal from CN1-29, -30 output terminal.
Speed Coincidence Detection Signal Mapping (/V-CMP)
Reference
Section
0 to 3
Same as /COIN Signal Mapping.
5.3.8
Servomotor Rotation Detection Signal Mapping (/TGON)
Reference
Section
0 to 3
Same as /COIN Signal Mapping.
5.10.3
Servo Ready Signal Mapping (/S-RDY)
Reference
Section
0 to 3
Same as /COIN Signal Mapping.
5.10.4
4th 3rd 2nd 1st
digit digit digit digit
n.


Table of Contents

Related product manuals