YASKAWA JUSP-MD D01A Series - Page 348

10.2 List of Parameters
10-29
10
Appendix
Pn50F
2 Output Signal Selection 2 0000 to 3333 − 0000 After restart Setup −
Pn510
2 Output Signal Selection 3 0000 to 0333 − 0000 After restart Setup −
Pn511 2 Reserved (Do not change.) −− 8888 −−−
(cont’d)
Parameter
No.
Size Name
Setting
Range
Units
Factory
Setting
When Enabled
Classifi-
cation
Reference
Section
Torque Limit Detection Signal Mapping (/CLT)
Reference
Section
0 Disabled (the above signal is not used.)
5.8.5
1 Outputs the signal from CN1-25, -26 output terminal.
2 Outputs the signal from CN1-27, -28 output terminal.
3 Outputs the signal from CN1-29, -30 output terminal.
Speed Limit Detection Signal Mapping (/VLT)
Reference
Section
0 to 3
Same as /CLT Signal Mapping.
5.5.4
Brake Signal Mapping (/BK)
Reference
Section
0 to 3
Same as /CLT Signal Mapping.
5.2.4
Warning Signal Mapping (/WARN)
Reference
Section
0 to 3
Same as /CLT Signal Mapping.
5.10.2
4th 3rd 2nd 1st
digit digit digit digit
n.

Near Signal Mapping (/NEAR)
Reference
Section
0 Disabled (the above signal is not used.)
5.4.7
1 Outputs the signal from CN1-25, -26 output terminal.
2 Outputs the signal from CN1-27, -28 output terminal.
3 Outputs the signal from CN1-29, -30 output terminal.
Reserved (Do not change.)
Reference Pulse Input Multiplication Switching Output Signal Mapping
(/PSELA)
Reference
Section
0 to 3
Same as /NEAR Signal Mapping.
5.4.3
Reserved (Do not change.)
4th 3rd 2nd 1st
digit digit digit digit
n.
