Yealink T40G

Yealink T4 Series IP Phones User Guide
65
Note
If you press Cancel to go back to the idle screen, you can long press the BLF key to enter the Calls for Pickup screen again.
Setting a BLF Key
You can set a BLF key to monitor a specific line for status changes on the phone.
Procedure
1. Navigate to Menu > Features > Dsskey.
2. Select the desired line key.
3. Select BLF from the Type field.
4. Select the desired line from the Account ID field.
5. Do one of the following:
l (Optional.) Enter the string that will appear on the phone screen in the Label field.
Enter the phone number or the extension you want to monitor in the Value field.
l On the T46S/T46G phones, highlight the Label or Value field. Press Directory (Dir) and select a desired contact
from the Directory list.
On the T48S/T48G phones, tap , and then tap the desired contact.
6. (Optional.) Enter the directed call pickup code in the Extension field.
7. Select Save.
Tip
By default, you can long press the desired line key to set it.
Note
During a call, you can press the BLF key to select a transfer mode. Check with your system administrator to find out if this
feature is available on the phone.
Picking up a Remote Call by BLF Key
When the monitored users are not at their desks and someone rings their lines, you can pick up the desired call simply
by pressing the flashing BLF key.
If your system administrator set the directed call pickup code in advance, you can use the BLF key to pick up the call
directly. If not or if you want to set a pickup code for a specific BLF line, you can set a pickup code for BLF key manu-
ally.
Before You Begin