Yealink VC880 - Page 93

| Settings | 93
•
Dual Screen Layouts
•
Specifying Content to the Secondary Screen
Available Screen Layouts
The system supports the following layouts:
• 1+N: in this layout, the assigned participant is given prominence in the largest pane no matter who is currently
speaking, and other participants are displayed in a strip beside the assigned speaker.
• Selected Speaker: in this layout, the selected participant is displayed in full screen.
• Equal N×N: in this layout, every participant is given equal prominence in equal-sized panes.
• Picture-in-picture: PIP only takes effect on the local layout. In a two-way video call, the video on one end is
displayed in a large screen, and the small screen of the other end is superimposed on the lower right side of the
large screen. In the YMS/Cloud conference, the large screen displays the conference layout and the small screen
displays the local video.
• Speaker View: the active speaker is given prominence in the largest pane and other participants are displayed in a
strip beside the active speaker. This screen layout is not available on the VC500/VC200 endpoint.
Changing the Screen Layout
You can change the screen layout during a call by the remote control/CP960.
Procedure
1.
Do one of the followings during a call:
•
On your remote control, press .
• For VC880/VC800/VC500/PVT980/PVT950, on your remote control, press OK key to open Talk Menu, and
then select Layout Adjustment > Layout.
For VC200, on your remote control, press OK key to open Talk Menu, and then select Layout.
• On your CP960, tap Layout.
2.
Select the desired layout.
Related concepts
Available Screen Layouts
Single Screen Layouts
The following introduce the default layout when you connect one display.
Two-Way Video Call
Picture-in-picture layout is used by default.