9-12 IM 04L20A01-01E
• Action
Select the action to be assigned from the following. Select [None] if you are not
assigning any action. Enclosed in [ ], are displays on the soft key menu.
• MemoryStart/Stop [Memory]
Starts/stops the acquisition of the display data/event data to the internal memory
and the report function (/M1, /PM1 option).
• Trigger [Trigger]
This input is used as an external trigger for starting the acquisition of the event data
to the internal memory.
• AlarmACK [AlarmACK]
Releases the alarm indication and relay output (option). This is the same function
as when the [AlarmACK] soft key is pressed.
• Time Adjust [Time adj]
Adjusts the internal clock of the FX100 to the nearest hour depending on the time
when the remote signal is applied.
• MathStart/Stop [Math] (/M1, /PM1 option)
Starts/stops the computation.
• ManualSample [M.sample]
Write measured data of all channels to the internal memory once.
• Panel1Load [Pnl1 load], Panel2Load [Pnl2 load], Panel3Load [Pnl3 load]
(only on models with the storage medium drive)
Loads the setup data file named “LOAD1.PNL”, “LOAD2.PNL”, or “LOAD3.PNL”
stored on the external storage medium and activates the settings.
• Message1 [Message1] to Message8 [Message8]
Displays a message at the position corresponding to the time when the signal was
applied on the trend screen. The displayed message is also written to the internal
memory.
• Snapshot [Snapshot]
Saves the current screen image data to the external storage medium. Snapshots
can be taken in any mode (operation mode, setting mode, or basic setting mode).
This function is available on the models with an external storage drive, or models
with the Ethernet communication interface (/C7 option) that are set up for snapshot
FTP transfer.
• Pulse [Pulse] (/PM1 option)
You can use the remote input terminals as the pulse input terminals.
For the description of the pulse input, see section 4.3.
9.6 Setting the Remote Control Function (/R1, /PM1 Option)
To Next Page
Loading...
Need help?
General
