3-14 IM 04L20A01-01E
3.5 Initializing the Setup Data and Clearing the
Internal Memory
This section explains how to initialize the setup data in the internal memory to factory
default settings (initial settings) and how to clear the data in the internal memory.
For a list of initial settings, see appendix 6.
Initializing the Setup Data / Clearing the Internal Memory <Basic Setting Mode>
Procedure
Opening the Setting Display
MENU key (switch to setting mode) > Hold down the FUNC key for 3 seconds
(switch to basic setting mode) > #8 soft key (select [Save/Load, Initialize]) > #5 (or
#1
*
) soft key (select [Initialize])
* For models with no external storage drive.
From the operation mode, use the above keys to open the following setting display.
Setup Procedure
1. Press the soft key corresponding to the action you wish to carry out.
2. Press the DISP/ENTER key.
A confirmation dialog box appears.
3. Select [Yes] and press the DISP/ENTER key.
The action is executed and the FX100 returns to the operation mode.
To cancel the action and return to the operation mode, select [No] using the
arrow keys and press the DISP/ENTER key.
Setup Items
Clearing the Internal Memory
• Select the type of action from the following:
Clear1: Initializes the setup data of basic setting mode and setting mode and clears
the data in the internal memory.
Clear2: Initializes the setup data of setting mode and clears the data in the internal
memory.
Clear3: Clears the data in the internal memory.
• Data That Are Cleared
Items that are cleared are, display data, event data, manual sampled data, TLOG
data (/M1, /PM1 option), report data (/M1, /PM1 option), and log information.
To Next Page
Loading...
Need help?
General
