5-3
IM 04P03B01-01E
Troubleshooting
5
Code Message Sent via Communication Explanation/Countermeasures
396 Failed to disconnect. –
397 No TCP control block. The control block of the specified connection cannot be found.
400 Input username. –
401 Input password. –
402 Select username from ‘admin’ or ‘user’. If the recorder is configured not to use the user name and
password, use user names ‘admin’ or ‘user’.
403 Login incorrect, try again! –
404 No more login at the specified level is acceptable. –
420 Connection has been lost. –
421 The number of simultaneous connection has been –
exceeded.
422 Communication has timed-out. –
Warning Messages
Code Message Sent via Communication Explanation/Countermeasures
600 Initialized. Settings and measured data have been initialized.
System Errors
Code Message Sent via Communication Explanation/Countermeasures
902 RAM failure. Contact your nearest YOKOGAWA dealer.
910 A/D error. Contact your nearest YOKOGAWA dealer.
921 A/D calibration value error. Contact your nearest YOKOGAWA dealer.
922 A/D calibration is in the wrong order. Contact your nearest YOKOGAWA dealer.
930 Memory acquisition failure. Contact your nearest YOKOGAWA dealer.
940 The ethernet module is down. Contact your nearest YOKOGAWA dealer.
950 A/D number error. Contact your nearest YOKOGAWA dealer.
951 EEPROM write error. Contact your nearest YOKOGAWA dealer.
960 Ribbon error Contact your nearest YOKOGAWA dealer.
961 Printer error Contact your nearest YOKOGAWA dealer.
962 Plotter error Contact your nearest YOKOGAWA dealer.
963 Pen 1 error Contact your nearest YOKOGAWA dealer.
964 Pen 2 error Contact your nearest YOKOGAWA dealer.
965 Pen 3 error Contact your nearest YOKOGAWA dealer.
966 Pen 4 error Contact your nearest YOKOGAWA dealer.
5.1 A List of Error Messages
To Next Page
Loading...
Need help?
General
