11-4 IM 760301-01E
Code Message Corrective Action Reference Section
806 Cannot be set or executed in the – –
FFT measurement mode.
807 Cannot be set or executed – –*
in the Cycle by Cycle measurement mode.
808 Cannot change this parameter during – –
numerical display.
809 Cannot change this parameter during vector – –
display.
810 Cannot change this parameter during bar – –
graph display.
812 Cannot be set while storing/recalling of data – –
being performed.
813 Cannot be set while integration is running. Reset Integration. 5.14
820 Cannot be set or executed in the Flicker – –*
measurement mode.
821 Attempt made to start flicker measurement Wait for the initialization to finish and the WT3000 –*
while flicker initialization is not finished. to become ready. Then, start the measurement.
822 Attempt made to start flicker measurement Reset the flicker measurement, wait for the –*
while flicker measurement is in progress or initialization to finish, and start the measurement.
result of flicker judgement is displayed.
823 Cannot change during CAL. Wait until CAL is completed. 10.1
824 Attempt made to initialize flicker Reset the flicker measurement and then execute –*
measurement while flicker measurement is initialization.
in progress or resultof flicker judgement is
displayed.
825 Cannot change limit settings while flicker Can be changed only when the measurement is –*
measurement is in progress. reset or while the judgement result is being
displayed.
826 Cannot be set or executed when flicker Reset the flicker measurement. –*
measurement is not reset.
827 Illegal math expression. Input a correct computing equation. 5.4
828 Cannot start flicker measurement when all Perform judgement or move the observation period –*
periods of dmax measurement are finished. if necessary and measure again.
829 Cannot judge flicker measurement until all Perform judgement after the dmax measurement of –*
periods of dmax measurement are finished. all observation periods is finished.
830 Cannot move period while flicker – –*
measurement is not ready.
831 Processing now. Retry setting or execution again. –*
836 Cannot be set or executed while Cycle by Reset the cycle-by-cycle measurement. –*
Cycle measurement is not reset.
841 Attempted to start integration after Reset Integration. 5.14
integration time has reached its preset value.
842 Attempted to start integration while – 5.14
integration is in progress.
843 Measurement stopped due to overflow Reset Integration. 5.14
during integration or due to a power failure.
844 Attempted to stop integration even though – 5.14
integration was not in progress.
845 Attempted to start integration while – 5.14
integration was in progress or integration
mode was not selected.
846 Attempted to start integration while – 5.14
measurement of peak overflow was
in progress.
847 Attempted to start integration in continuous – 5.11
integration mode when integration preset
time was set to “0”.
11.2 Error Messages and Corrective Actions
To Next Page
Loading...
Need help?
General
