P1036102-007 ZXP Series 7 Card Printer Service Manual 95
Replacement Procedures for the Printer
Procedures: Print Engine
Step 4. Remove the retaining clip; and then remove the washer, spring, pressure
plate, felt washer, gear, and felt washer.
WASHER
SPRING
PRESSURE PLATE
FELT WASHER
GEAR
FELT WASHER
Ribbon Sync Sensor
Step 1. Unplug the ribbon sync sensor cable-to-cable connection.
Step 2. With a TORX T8 driver, remove the two screws holding the Ribbon Sync
Sensor in place.
To Next Page
Loading...
