98 ZXP Series 7 Card Printer Service Manual P1036102-007
Replacement Procedures for the Printer
Procedures: Print Engine
Step 3. Remove the Antenna, and set it aside.
Supply Spindle Motor
Step 1. With a TORX T10 driver, remove the two screws holding the Supply Spindle
Motor in place. When replacing the screws, loosely tighten; then fully tighten
when replacing the Bearing Plate (page 94).
Step 2. Cut the cable ties as required to free the motor cable.
Step 3. Unplug the supply spindle motor cable-to-cable connection.
To Next Page
Loading...
