P1036102-007 ZXP Series 7 Card Printer Service Manual 189
Replacement Procedures for the Printer
Procedures: Torque Tools Calibration Instructions
Step 7. While observing the dial on the Torque Watch, record the AVERAGE high
vs. low value that the needle indicates. The average must be between 13
~ 15 in-oz. for the ZXP7 High Torque Tool and 4 ~ 6 in-oz for the ZXP7 Low
Torque Tool.
Step 8. If the AVERAGE value is outside of the specified range for the Torque Tool
being tested, the tool will need to be sent in for repair/calibration.
To Next Page
Loading...
