Zebra ZXP 7 series - Page 251

P1036102-007 ZXP Series 7 Card Printer Service Manual 245
Replacement Procedures for the Laminator
Procedures: Halogen Bulbs
Replacement
Replacement is performed by reversing the removal steps.
After installing the replacement Halogen Bulb(s), use a Multimeter to verify that both
bulbs are making proper connection.
Bottom bulb
connector pins
Top bulb
connector pins
Step 1. With a Multimeter, measure the resistance across the Top Bulb connector
pins.
Step 2. Resistance should range between 8 ohms and 15 ohms.
Step 3. With a Multimeter, measure the resistance across the Bottom Bulb connector
pins.
Step 4. Resistance should range between 8 ohms and 15 ohms.
Step 5. If the resistance is our of range, re-seat the Halogen Bulb(s), and repeat the
resistance measurement.