Zebra ZXP 7 series Service Manual

328 ZXP Series 7 Card Printer Service Manual P1036102-007
Replacement Procedures for the High-Capacity Output Hopper
Procedures: Sensors
Step 8. Secure the base cover and latch assembly to the stacker assembly using the
four (4) screws.
Step 9. Reinstall the left side panel; see “Left Side Panel” on page 304.
Stacker Entry Sensor
The stacker entry sensor is part of the base housing. For replacement procedure, see
“Base Housing” on page 347.

Zebra ZXP 7 series Specifications

General

Print Resolution	300 dpi
Connectivity	USB 2.0, Ethernet
Memory	64 MB standard
Print Technology	Dye-sublimation thermal transfer
Card Capacity	200 cards input hopper, 100 cards output hopper
Card Sizes	CR-80 ISO 7810, 2.12" (54 mm) x 3.38" (86 mm)
Power Requirements	100-240 VAC, 50-60 Hz