72 ZXP Series 7 Card Printer Service Manual P1036102-007
Replacement Procedures for the Printer
Procedures: Printer
Step 9. From the front of the Printer: With a TORX T10 driver, remove the two screws
holding the modules together.
Step 10. Lift the Feeder/Flipper/Options Assembly, and slide it to the right.
Step 11. Disconnect the two ground wires and cut the cable tie.
Step 12. Separate the Print Engine from the Feeder/Flipper/Options Assembly.
PRINT ENGINE OPTIONS
FLIPPER /
FEEDER
To Next Page
Loading...
