Input settings
Input limiter
60
The limiter can prevent distortion by controlling input signals
that have excessively high levels.
Threshold
Level
Original
signal
Limited
signal
Attack
time
Release
time
Time
When the limiter is ON, if the input signal level exceeds the
set threshold value, the signal level will be suppressed to pre-
vent the sound from distorting.
The attack time is how long after the signal exceeds the
threshold until the limiters starts operating. The release time
is how long after the signal goes below the threshold until the
limiters stops operating. You can change these two parame-
ters to adjust the sound quality.
HINT
• The
uses a newly-designed limiter. This limiter has 10
dB of headroom, preventing distortion and allowing it to keep
signals below the set threshold even more than ordinary limiters.
• The limiter uses a ratio of 20:1.
1. Press .
2. Use to select “
INPUT
”,
and press
.
3. Use to select “
Input
Limiter
”, and press .
4. Use to select the track,
and press
.
HINT
Select “
ALL
“ to set all the tracks at the same time.
Input limiter
To Next Page
Loading...
Need help?
General
