Zoom F8 - Stopping Timecode Output; Synchronizing Audio Clock with External Timecode

TIMECODE
Setting timecode
90
Setting timecode (continued)
Stopping timecode output when recording is stopped
You can set whether or not timecode is output from the
TIMECODE OUT jack when recording is stopped.
4. Use to select “ Mode ”,
and press
.
5. Use to select “ Int Auto
Mute
”, and press .
6. Use to select “ On ”, and
press
.
NOTE
• Timecode will continue to be output when recording/playback is
paused.
• This cannot be set when Mode is set to Off, Ext or Ext Auto Rec.
Synchronizing audio clock with external timecode
4. Use to select “ Mode ”, and
press
.
5. Use to select “ Ext Audio
Clock Sync
”, and press .
6. Use to select “ On ”, and
press
.
NOTE
• This cannot be set when Mode is set to Off, Int Free Run, Int
Record Run or Int RTC Run.
• When there is no external timecode, the internal audio clock is
enabled to preserve continuity.