Zoom F8 - Setting Signals Sent to Headphones (Headphone Routing); Setting Headphone Routing

Output settings
Setting signals sent to headphones (Headphone Routing)
72
1. Press .
2. Use to select “ OUTPUT ”,
and press
.
3. Use to select
“
Headphone ”, and press .
υ Continue to one of the following procedures.
Setting the routing ............................................................P.72
Using mono headphone output .......................................P.73
Monitoring mid-side stereo signals .................................P.74
Setting the routing
4. Use to select “ Headphone
Routing
”, and press .
5. Use to select the tracks/outputs for headphone
routing and press
.
Clear all settings
Mono mix
Tracks routed to the
left headphone
channel
Tracks routed to the
right headphone
channel
Set tracks 1–8
to prefader
(deactivates MS)
Mid-side stereo
monitoring
Cycles options:
• Change tracks 1–8 to
postfader (cancels others)
• Change L/R to postfader
(cancels others)
• Change M1/M2 to
postfader (cancels others)
• Change S1/S2 to
postfader (cancels others)
(deactivates MS)
Prefader selected
Postfader selected
Off
You can set the type of signal sent to the headphone output to either prefader or postfader for each track.
Setting signals sent to headphones (Headphone Routing)