Zte ZXA10 C300 - Figure 16-2 Configuration Flowchart of Basic MPLS Function

Chapter16MPLSServiceConguration
Figure16-2CongurationFlowchartofBasicMPLSFunction
Steps
lCongurationonC300-1.
1.Conguretheloopbackinterface.
ZXAN(config)#interfaceloopback1
ZXAN(config-loopback1)#ipaddress1.1.1.1255.255.255.255
ZXAN(config-loopback1)#exit
2.ConguretheVLANoftheuplinkinterfaces.
ZXAN(config)#interfacegei_1/21/1
ZXAN(config-if)#switchportvlan10tag
ZXAN(config-if)#exit
3.ConguretheIPaddressoftheVLANinterface.
ZXAN(config)#interfacevlan10
ZXAN(config-if-vlan10)#ipaddress10.1.1.1255.255.255.0
4.EnabletheMPLSontheVLANinterface.
ZXAN(config-if-vlan10)#mplsip
ZXAN(config-if-vlan10)#exit
5.Conguretheroutingprotocol.
ZXAN(config)#routerospf1
ZXAN(config-router)#network1.1.1.10.0.0.0area0.0.0.0
ZXAN(config-router)#network10.1.1.00.0.0.255area0.0.0.0
ZXAN(config-router)#exit
6.EnabletheglobalMPLSfunction.
ZXAN(config)#mplsldprouter-idloopback1
ZXAN(config)#vlan-reserve4090vpn
16-3
SJ-20130520164529-007|2013-06-30(R1.0)ZTEProprietaryandCondential