Zte ZXA10 C300 - Chapter 17 OAM Configuration; 17.1 Ethernet OAM Configuration; 17.2 BFD Configuration

Chapter16MPLSServiceConguration
Figure16-6CongurationFlowchartofLDPFRRFunction
Steps
lCongurationonC300-1.
1.Conguretheloopbackinterface.
ZXAN(config)#interfaceloopback1
ZXAN(config-loopback1)#ipaddress1.1.1.1255.255.255.255
ZXAN(config-loopback1)#exit
2.ConguretheVLANoftheuplinkinterfaces.
ZXAN(config)#interfacegei_1/21/1
ZXAN(config-if)#switchportvlan10tag
ZXAN(config-if)#exit
ZXAN(config)#interfacegei_1/21/2
ZXAN(config-if)#switchportvlan13tag
ZXAN(config-if)#exit
3.ConguretheIPaddressoftheVLANinterfaces.
ZXAN(config)#interfacevlan10
ZXAN(config-if-vlan10)#ipaddress10.1.1.1255.255.255.0
ZXAN(config-if-vlan10)#exit
ZXAN(config)#interfacevlan13
ZXAN(config-if-vlan13)#ipaddress13.1.1.2255.255.255.0
ZXAN(config-if-vlan13)#exit
4.EnabletheMPLSontheVLANinterfaces.
ZXAN(config)#interfacevlan10
ZXAN(config-if-vlan10)#mplsip
16-15
SJ-20130520164529-007|2013-06-30(R1.0)ZTEProprietaryandCondential