Zte ZXA10 C300 - 2.1 Configuring the GPON ONU Type Profile

Chapter2GPON/XG-PONServiceConguration
2.1ConguringtheGPONONUTypeProle
BeforeauthenticatingtheGPONopticalnetworkunit(ONU),youneedtocreateanONU
typeproleiftheONUtypedoesnotexist.
Context
TheZXA10C300supportsthefollowingdefaultGPONONUtypes.
lZTE-F601
lZTE-F621
lZTE-F622
lZTE-F625
lZTE-F628
lZTE-F640
lZTE-F641
TheZXA10C300supportstheonlyonetypeofXG-PONONU:ZTE-F220.
OntheZXA10C300,ZTE-9806,ZTE-F822,andZTE-F820areEPONONUtypes.If
youneedtocongurethecorrespondingGPONONUtype,youcanuseZTEG-9806H,
ZTEG-F822,andZTEG-F820respectively.
Youcanusetheshowonu-typegponcommandtoquerythedefaultGPONONUtypes.
CongurationData
Table2-1liststhecongurationdataoftheGPONONUtype.
Table2-1CongurationDataoftheGPONONUType
ItemData
ONUtypeZTEG-F620
ONUdescription4ETH,2POTS
MaximumT-CONT7
MaximumnumberofGEMports32
Maximumnumberofswitchunitsperslot1
Maximumnumberofowsperswitchunit8
NumberofuserportsETH:4
POTS:2
Steps
1.Enterglobalcongurationmode.
ZXAN#configureterminal
Enterconfigurationcommands,oneperline.EndwithCTRL/Z.
ZXAN(config)#
2.InPONcongurationmode,createanONUtypeprole.
2-3
SJ-20130520164529-007|2013-06-30(R1.0)ZTEProprietaryandCondential