Zte ZXA10 C300 - 12.2 Configuring UAPS

Chapter12UplinkProtectionConguration
gei_1/21/2inactive30327680x1000x45port-disableddefaulted
–EndofSteps–
12.2ConguringUAPS
ThissectiondescribeshowtocongureUAPStoimplementautomaticprotection
switchoveroftheuplinkport.
Context
TheZXA10C300supportstheuplinkautomaticprotectionswitching(UAPS)function.The
systemperiodicallycheckstheworkingstatusoftheuplinkport.Whenthesystemdetects
thatthelinkoftheworkingportisdisconnectedorthelinkisnotavailableduetolink
qualitydegradation,itswitchestheservicestothestandbyportautomaticallyandwithout
interruptingtheservices.
Steps
1.Inglobalcongurationmode,createaUAPSgroup.
ZXAN(config)#uaps-group1
ZXAN(cfg-uaps-1)#
2.Conguretheactive/standbyportsoftheUAPSgroup.
ZXAN(cfg-uaps-1)#portmaster-portgei_1/21/1slave-portgei_1/21/2
Note:
Thecongurationdataontheactiveportandstandbyportshouldbeconsistent.
3.Enableactive/standbyauto-switchfortheUAPSgroup.
ZXAN(cfg-uaps-1)#revertiveenable
4.ConguretheUAPSgroupprotectiontime.
ZXAN(cfg-uaps-1)#protect-time400
IftheUAPSgroupimplementsswitchoveronce,itdoesnotimplementswitchover
againduringtheprotectiontime.
5.ConguretheportattributeoftheUAPSgroup.
ZXAN(cfg-uaps-1)#switch-typecommon-port
12-5
SJ-20130520164529-007|2013-06-30(R1.0)ZTEProprietaryandCondential