2N Access Unit - 2 N Access Unit Configuration Manual; ;

2N Access Unit Configuration Manual
120 / 134
•
•
•
•
•
•
•
•
•
•
•
•
•
•
DHCP (Option 66/150) Address– check the server address retrieved via the DHCP Option
66 or 150.
File Path– set the firmware/configuration filename directory or prefix on the server. The
intercom expects the XhipY_firmware.bin, XhipY-common.xml and XhipY-MACADDR.xml
files, where X is the prefix specified herein and Y specifies the intercom model.
Use Authentication–enable authentication for HTTP server access.
Username–enter the user name for server authentication.
Password–enter the password for server authentication.
Trusted Certificate– set the set of CA certificates for validation of the ACS public
certificate.
User Certificate– specify the user certificate and private key to validate the intercom
right to communicate with the ACS.


At Boot Time– enable check and/or execution of update upon every2NAccess Unitstart.
Update Period–set the update period. Set an automatic update to take place hourly/
daily/weekly/monthly, or set the period manually.
Update At– set the update time in the HH:MM format for periodical updating at a low-
traffic time. The parameter is not applied if the update period is set to a value shorter than
1 day.
Next Update At– display the next update time.
Last Update At–last update time.
Update Result–last update result. The following options are available:DHCP option 66
failed, Firmware is up to date, Server connection failed, Running..., File not found.
Communication Result Detail– server communication error code or TFTP/HTTP status
code.