2N Access Unit - 2 N Access Unit Configuration Manual; ;

2N Access Unit Configuration Manual
78 / 134
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Module Name– set the module name for card reader logging purposes.
Door–set the reader direction (Not specified, Arrival, Departure) for the Attendance
system purposes.
Associated Switch–set the switch to be activated after user authentication via this
module. If you set Door Lock Switch, the authentication rules specified in Hardware / Door
will be used.
Allowed Card Types– set the type of a card to be accepted by the card reader. The card
reader supports just one card type at an instant.
Samsung NFC Compatibility–enable NFC compatibility with the Samsung phones.
Forward to Wiegand Output– set a group of Wiegand outputs to which all the received
RFID card IDs will be resent.
Bluetooth(serial number)
Module Name–set the module name for logging events from the Bluetooth module.
Door–set the reader direction (Not specified, Arrival, Departure) for the Attendance
system purposes.
Associated Switch–set the switch to be activated after user authentication via this
module. If you set Door Lock Switch, the authentication rules specified in Hardware / Door
will be used.
Signal Range– set the maximum signal range, i.e. the distance within which the
Bluetooth module can communicate with the mobile phone:
Short–less than 2 m for most phones
Long– maximum possible range
Operation Mode–set the authentication method for a mobile phone:
Tap in app– authentication has to be confirmed by tapping on an icon in the
application running in a mobile phone.
Touch mode– touch the card reader having a phone with paired2N
®
Mobile Key to
confirm authentication.