2N Access Unit - 2 N Access Unit Configuration Manual; 5.3.7 Digital Inputs; ;

2N Access Unit Configuration Manual
59 / 134
•
•
5.3.7 Digital Inputs
In this configuration section set the parameters associated with the digital inputs and their
interconnections with other functions.
List of Parameters
Assigned input– define one (or none) of the logical inputs for secured state detection.
The secured state is then signalled by a red LED on the2NAccess Unit.
Input mode– set the active level of the input (polarity).
The tamper switch equipped models help detect opening of the device cover and signal this
event asTamperSwitchActivated. The events are written into a log and read out via HTTP API
(refer to theHTTP APImanual).