2N Access Unit - 2 N Access Unit Configuration Manual; ;

2N Access Unit Configuration Manual
41 / 134
•
•
•
•
•
•
Synchronise with– set switch synchronisation to enable automatic switch activation
after another switch activation with a predefined delay. Define the delay in
theSynchronisation Ddelayparameter.
Synchronisation Delay– set the time interval between synchronised activations of two
switches. The parameter will not be applied unless theSynchronisefunction is enabled.
Switch-On Command– set the command to be sent to the external device (WEB relay,
e.g.) upon switch activation. The command is sent via the HTTP (GET request) and must be
as follows:http://ip_address/path. E.g.:http://192.168.1.50/relay1=on.
Switch-Off Command– set the command to be sent to the external device (WEB relay,
e.g.) upon switch deactivation. The command is sent via the HTTP (GET request) and must
be as follows:http://ip_address/path. E.g.:http://192.168.1.50/relay1=off
Username– enter the username for the external device (WEB relay, e.g.) authentication.
The parameter is obligatory only if the external device requires authentication.
Password– enter the externaldevice (WEB relay, e.g.) authentication password. The
parameter is obligatory only if the external device requiresauthentication.